DC/DC modules with the power of 10W
They are meant for power supply of the voltage-stabilized analog and digital special- and industrial-purpose equipment. They are applied in radio receiving/transmitting devices, requiring high stability of the supply voltage and low noise level. A wide operating temperature range (from -60°Ñ to +85°Ñ) and high reliability allow it applying in tough climatic conditions. Technical characteristics: Family: Output volt./nomin. load current 5 V – 2 À 8 V – 1,25 À 12 V - 0,83 À 15 V – 0,66 À 27 V – 0,37 À - input voltage range from 10 to 36 V; - galvanic isolation input/output; - remote on/off - output voltage control ±5%; - protection from overload/ short circuit at the output, with automatic return to the operating mode after the ending of overload/short circuit (the time of short circuit is not limited); - typical efficiency factor is not less than 75%; -output voltage pulse amplitude (peak-peak), not more than 100mV; - output voltage pulse (rms value), not more than 10 mV (in the frequency range not less than 10 kHz); - insulating strength between input and output pins is 500 V of the direct voltage; - insulation resistance between input and output pins in not less than 20 MOhm.
Climatic parameters: - operating temperature range is from minus 60°Ñ to +85°Ñ; - resistance to hyperhumidity to 98% at the temperature +40°Ñ; - reliability parameters: - average service life is not less than 15 years; - manufacturer guarantee period is 5 years; - constructive parameters: - overall dimensions 50,8Õ25,3Õ10,2 mm (1/8 brick); - mass is not more than 40 gr; - pin locations comply with the foreign standards. |
Back to the section